It is often faster than you think: A small stone is thrown up from the road and hits the windshield at a speed of over 100 km / h – a stone chip in the windshield is a reality that quickly. Although the damaged area is often barely visible, it should not be taken lightly as it can cause a lot of trouble over time. A barely visible rockfall can turn into a crack in the windshield, which means a serious safety risk. The stone chipping of the windshield must therefore be treated. How to act correctly in the event of a stone chip in the windshield.
Clear Definitions For The Repair
Do you think you always have to have the entire windscreen changed at the glazier or in the workshop? Then you have been thinking wrong up to now, because stone chips on the windshield can often be repaired. For this, however, there are some requirements. In this way, only damage that is on the outer of the two car windows can be repaired. In addition, the impact of stones on the windshield must not be larger than a two euro coin and it must be at least ten centimeters away from the edge of the windshield. The stone chips from the windshield must also not be in the driver’s field of vision.
Four Steps To Repairing The Damage
Only an expert can judge whether a repair is really possible or whether the pane has to be completely replaced. The repair of the damage is divided into four steps. So the specialist begins to clean the stone chips on the windshield. He then attaches a vacuum pump over the rockfall so that the hole can be filled with a special heart. This resin is then cured by UV light. Finally, the specialist polishes the windshield. Normally this does not take longer than 30 minutes, while the costs are covered by the comprehensive insurance. However, if you have not taken out comprehensive insurance, you must reckon with costs between 80 and 100 euros due to the rockfall of your windshield.
Gentle After Replacing The Glass
If the stone chip in the windshield is so severe that it can no longer be repaired, the specialist must replace the windshield. To do this, the rearview mirror is first removed and the interior covered. In addition, the windscreen wipers and the windscreen are removed below the windscreen. Now the professional can separate the adhesive from the pane with a thin wire. In this way, the damaged pane can be easily lifted out. Excess adhesive residue is removed before the new pane is installed. If the adhesive surface on the car frame and on the windshield has been primed, a special adhesive can be applied to the new windshield, which is then used. The glue has to harden for about three hours. You should note that the new pane can only be used again after 48 hours.